Did some cerakote over the weekend had some leftover OD from doing the upper and lower receivers so I did my form one suppressor changed the end cap and thread protector with ronin pro they are high but they are awesome and they come with a wrench to take them on and off
Then I painted my pt 809 also turned out better than I expected
P.S still have a stamp left Jim I really love your prototype I'm waiting .....
I would love to do a form one for my veper 12 ga got some ideas but would like some input
I know that I would have to be a internal drilled tube to keep the shot intact until it leaves the barrel but after that I'm lost ...
Jim help I think that a 2" tube would be a must with maybe a 3/4 inside tube ported so the gas can be funneled into the Baffels but that is where I'm at
It's a 15" handguard 8.5 barrel with a 9" tube it's the same setup I used on the sand color one in the earlier post if I could figure out how to load a video I have some awsome one comparing freeze plug cans to 60 degree cones and the m baffles from ronin pro and people would be shocked other than weight freeze plugs are as good if not better
Who is online
Users browsing this forum: No registered users and 1 guest